Finishing off a parchment craft card

After you have spent a good many hours on a parchment craft project, you probably want to finish it off neatly and be looking for a means of attaching your parchment creation to the card. Glue marks and double sided tape can be seen through parchment paper spoiling your work.  Here are several ways you can attach the parchment paper and finish off the card.


You can use very tiny drops of Perga Glue or Perga Kit: find some heavy embossing, coloured area or embellishment and hide the glue behind those areas, be careful though, if possible try on scrap parchment first.  


You can use brads or eyelets at each corner, or as part of the design, for example coloured brads could be used as the centre of flowers. Brads and eyelets can be bought  in loads of colours shapes and sizes.

Free Parchment Craft Pattern 'Spirals'


Tiny brads have been used to fixed this parchment craft square to the backing card at each corner.


If there are a pattern of holes around the edge you could sew the parchment using silver or gold thread.


Gold Thread has been used around the edge of the circle, holding the parchment to the card.


Another way you can attach or display a parchment design is by using a corner punch that has slots.


These slotted corners are produced with a Woodware Cloud Corner Punch


An aperture card can also give a neat finish to parchment craft. The parchment becomes easy to fix to the card in areas where it won’t be seen!


Aperture card decorated with a scalloped edge from a Siesta grid.


The traditional method of fixing parchment to card  is to have both front and back in parchment paper and then sew the parchment to the card at the spine.



 First of all, lay the card open and mark the centre with a pencil then mark two points equally spaced from the centre where you wish to sew the card. Then using a sharp thickish needle make a hole through both the card and the parchment on each of the three marks. I use a tapestry needle and thick cotton thread – starting on the inside of the card push the needle and thread through the centre hole (leaving a longish piece of thread) and then down through the upper hole, next up again through the centre hole and down through the lower hole. On the inside of the card pass the needle through the loop, pull it tight and tie a knot with the thread you left at the beginning. The knot can be completely covered by fixing an insert to the inside of the card with double sided tape.

I hope this is helpful – let me know in the comments below if you have another method of fixing parchment paper to card.